TM-5-4310-389-14
Figure 5-66. Setting the Refacing Tool
9.
After adjusting, secure the device by means of the setscrew (figure 5-66).
10.
Turn spindle of device clockwise to reface the cylinder seating.
NOTE
The feed is automatic when turning the spindle clockwise.
Remove only so much material as is necessary for obtaining a satisfactory sealing surface.
11.
Loosen the setscrew and, by means of the knurled nut, raise the cutter from the reworked surface prior to
removing the device.
12.
After refacing the cylinder seating, clean the crankcase. The seating surface must be plane and free from
grooves.
5-39
