TM-5-4310-389-14
t.
Crankshaft Belt Pulley.
NOTE
Alternator removed.
1.
Remove the V-belt and mark the position of the flywheel. Slacken and remove the nuts (figure 5-58) on the
V-belt pulley using retainer No. 003-0446.
2.
Remove V-belt pulley (figure 5-59).
3.
Align the cutout in the V-belt pulley with the feather of the crankshaft gear wheel and slide the V-belt pulley
into position.
4.
Tighten the nut in accordance with torque specifications listed in Appendix F (use retainer
No. 003-0446).
5.
Mount and tension the V-belt.
6.
Install belt at minimum pulley spacing.
7.
Tension the V-belt so that its free movement midway between the two pulleys is 1/8 to 1/2-inch (10 to 15
mm) when pressure is applied with the thumb.
8.
Tension belt by swinging alternator outwards. Tighten strap bolt.
Figure 5-58. Remove Pulley Retaining Nut
Figure 5-59. Removing V-Belt Pulley
5-34