TM 5-4310-451-14
5-102. OIL SEPARATOR REPLACEMENT.
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Equipment Conditions:
Materials/Parts:
áRight side roof panel removed (see paragraph 5-82)
áSealing compound (Item 14, Appendix E)
áCenter roof panel removed (see paragraph 5-85)
áSix lockwashers
áMinimum pressure valve removed (see para-
graph 5-104)
Tools/Test Equipment:
áSafety relief valve removed (see paragraph 4-88)
áGeneral mechanic’s tool kit
áThermal valve removed (see paragraph 4-89)
áField automotive shop set
áOil separator oil level gage removed (see paragraph
áSuitable lifting device
4-91).
áOil separator drain valve removed (see paragraph
Personnel Required: Two
4-94).
áOil separator oil fill tube removed (see paragraph
4-92).
áOil separator element removed (see paragraph 4-90).
a. REMOVAL
1.
Remove two nuts (13), screws (5), and clamps (4) from coupling (8).
2.
Remove two couplers (6) and coupling (8) from nipples (3 and 9). If damaged, remove two gaskets (7) from
couplers (6).
3.
Remove nipple (9), elbow (10), and nipple (11)
from dish
4.
Remove nipple (3) and elbow (2) from oil
separator (1).
5.
Attach suitable lifting device to oil separator (1).
6.
Remove two nuts (14), screws (17), and
lockwashers (16) from two brackets (18) and
frame (15). Discard lockwashers.
7.
Remove four screws, lockwashers, and nuts
holding oil separator to oil separator and fuel
tank support (see paragraph 4-86). Discard
lockwashers.
5-378
