TM 5-4930-207-34
CHAPTER 5
R E P A I R OF LUBRICATING EQUIPMENT
S e c t i o n I. AIR RECEIVER
(3) Refer to TM 5-4930-207-12 and remove
5-1.
General
drain cock, hose, valve, gage, and lines and fittings
The air receiver is mounted on the skid weldment.
of the air receiver.
It has a 450 psi maximum load. It provides com-
(4) Remove air receiver as shown in nu-
pressed air which forces lubricant and oil from
merical sequence in figure 5-1.
storage tanks through reel-mounted hoses.
b. Installation.
(1) Install air receiver in reverse order as
5-2. Air Receiver Removal and
illustrated in figure 5-1.
Installation
(2) Install air receiver drain cock, hose,
a. Removal
valve, gage, and lines and fittings as instructed in
TM 5-4930-207-12.
(1) Remove lines and fitting and air com-
pressor assembly as instructed in TM 5-4930-
(3) Refer to TM 5-4930-207-12 and install
207-12.
engine, generator mounting bracket, generator
assembly, and belt guard.
(2) Refer to TM 5-4930-207-12 and remove
(4) Refer to TM 5-4930-207-12 and install
belt guard, generator assembly, generator mount-
air compressor assembly and lines and fittings.
ing bracket. and engine.
Figure 5-1. Air receiver, removal and installation.
5-1
