TM9-4310-396-13
c. Remove fuel injection plunger (3). Add 2cc (4-6 drops) of engine oil.
d. Repeat step a., above.
e. If engine still does not start, follow next procedures in paragraph 2-11.3
2-11.3 Start Up at Temperatures Below 20°F (-7°C).
WARNING
Avoid coming in contact with metal with bare skin while in a cold environment.
Failure to observe this warning may result in severe personal injury or death.
NOTE
Heater will supply heated air into trailer base which will warm up storage battery,
engine, and compressor oil allowing easy start. Heated air should not be applied
for more than 30 minutes under coldest condition. In most conditions, warmer than
-50°F (-46°C), heater will warm engine enough to start in 10 - 15 minutes.
a. Obtain heater model PH-400-G or equivalent.
b. Remove heater inlet lid (1, Figure 2-20) and place on top of complete top hood assembly.
c. Install heater hose (2) directly to heater inlet adaptor (3).
Figure 2-20. Heater Hose and Heater Inlet Adaptor.
2-39
