TM9-4310-396-13d. Open all three vent louvers (1, Figure 2-21) on rear of complete top hood assembly.e. Close all access doors (2) and latch.f. Operate heater as directed on applicable heater instruction plate or heater manual.g. After warm up by use of heater, start engine (reference 2-6.7).Figure 2-21. TrailerVentLouvers.2-11.4AfterStarting.a. If heater was used, shut off heater and remove heater hose from compressor.b. If gages are operating, return to normal operating procedures. If gages are not operating, shut down engine andrefer to PMCS Table 2-3.2-12 DUSTY OR SANDY AREAS.CAUTIONWhen operating in blowing dust or sand, protect compressor frame control panelwith tarpaulins as necessary. Be careful not to close off air intakes or vent louvers.Protect fuel supply from dust and dirt contamination. Under extreme conditions,change filter element at least twice the normal frequency of once every six monthsor 500 hours, whichever comes first. When not operating, close and covercompressor as tightly as possible.2-12.1Operation. For startup and shutdown procedures, refer to paragraphs 2-6.7 and 2-6.8.2-40
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
