TM9-4310-396-13
CHAPTER 3
OPERATOR MAINTENANCE INSTRUCTIONS
Section I
Operator lubrication instructions...........................................................................
3-1
3-1
General ...............................................................................................................
3-1
Section II
Operator troubleshooting procedures ..................................................................
3-1
3-2
Introduction..........................................................................................................
3-1
3-2
Operator troubleshooting Table 3-1 .....................................................................
3-2
Section III
Operator maintenance procedures ......................................................................
3-8
3-3
General ...............................................................................................................
3-8
3-4
Service complete top hood assembly, frame control
panel, and vent louvers .......................................................................................
3-8
3-5
Maintenance of air filter element ..........................................................................
3-9
3-6
Service strainer assembly ...................................................................................
3-11
Section I - OPERATOR LUBRICATION INSTRUCTIONS
3-1 GENERAL.
Lubrication methods, procedures, and instructions are included in Lubrication Order LO9-4310-396-12. Reference this
manual for complete instructions.
Section II - OPERATOR TROUBLESHOOTING PROCEDURES
3-2 INTRODUCTION.
3-2.1 The Troubleshooting Table 3-1 lists the common malfunctions which you may find during the operation or
maintenance of the compressor or its components. You should perform the tests and inspections and corrective actions
in the order listed.
3-2.2 This manual cannot list all malfunctions that may occur, nor all tests or inspections and corrective actions. If a
malfunction is not listed or is not corrected by listed corrective actions, notify your supervisor.
3-2.3 Any trouble or corrective action beyond the scope of operator maintenance shall be reported to Unit maintenance.
3-1