TM 9-4310-397-14
(d)
Remove two socket head screws (4), lock washers (5), hose reel body retainer (6) and preformed packing (7).
Discard lock washers and preformed packing.
(e)
Remove hose reel assembly (3) and preformed packing (7). Discard preformed packing.
(f)
Remove four self locking nuts (8), hex head screws (9), and spindle (10). Discard self locking nuts.
(g)
Loosen setscrew (Figure 4-24, 1) and remove knob (2) from rod (3).
Figure 4-24. Inlet Housing Knob (Unloader)
(h)
Remove two hex washer head bolts (4), guide plate assembly (6), and grommet (5).
(i)
Tag wire leads (Figure 4-25, 1).
(j)
Remove lock nut (2), wire leads (1), and hex washer head bolt (3).
(k)
Loosen, but do not remove, screw (4). Remove push/pull cable (5).
(l)
Remove hex head screw (6) and clamp (7).
(m)
Remove nut (8) and pull push/pull cable assembly (9) through front of panel.
(n)
Remove four lock nuts (10), hex washer head bolts (11), and cold starting aid (12). Discard lock nuts.
(o)
Remove two cap screws (13) from cables (14) and (15) and pull cables from connector (16).
(p)
Remove eight pan head screw (17) and flat washers (18).
NOTE
Two personnel are required to complete removal of component parts.
(q)
Remove control panel (19) taking care not to damage rod (Figure 4-24, 3).
4-77