TM 9-4310-397-14
b.
Disassembly.
(1)
Remove double discharge valve (Figure 4-26, 1).
(2)
Remove four lock nuts (2), hex washer head bolts (3), and service valve pipe (4). Discard lock nuts.
(3)
Remove tee assembly (5).
(4)
Remove four self locking nuts (6) and pan head screws (7) from connector (8). Discard self locking nuts.
(5)
Remove two hex nuts (9), lock washers (10), pan head screws (11), flat washers (12), and bumpers (13).
Discard lock washers.
(6)
Drill out four rivets (14) from each door holder (15) located on side panels.
(7)
Drill out four rivets (16) from door assembly (17).
NOTE
Insulation has an adhesive backing and must be replaced if removed .
(8)
Peel off gaskets (18) and (19).
(9)
Remove bail handle stud (20) from retainer (21).
(10)
Drill out two rivets (22) from each anchor nut (23).
(11)
Drill out two rivets (24) from each anchor nut (25), as required, for replacement.
4-79
