TM 9-4310-397-14
4-31. COVERS, PANELS AND DOORS REPLACEMENT. - Continued
WARNING
Metal pins pierce insulation panels when installed. Injury to hands can result if care is not taken
when installing insulation panels.
(2)
Remove paper backing from insulation panel and install with sticky side against sheet metal panel. Carefully
locate pins and install new clips (1) (item 6, appendix H).
(3)
Install anchor nuts (Figure 4-26, 25) as required and secure with two rivets (24) (item 64, appendix H).
(4)
Install anchor nuts (23) as required and secure with two rivets (22) (item 64, appendix H).
(5)
Install door assembly (17) and secure with four rivets (16) (item 9, appendix H).
WARNING
Adhesive (item 5, section II, appendix E) is toxic and flammable. Use in well ventilated areas only.
Avoid breathing vapor and avoid repeated or prolonged contact with liquid. Do not use near open
flame or excessive heat.
(6)
Install bail handle stud (20) and retainer (21).
(7)
Install gaskets (18) and (19) as required, per the following:
(a)
Scrape off as much of the old gasket material from surface.
(b)
Remove old adhesive and gasket residue by scraping.
(c)
Cut gasket per appendix F.
(d)
Apply adhesive (item 5, section II, appendix E), to mating surfaces of metal and gasket.
(e)
Let surface air dry until adhesive is tacky but will not stick to fingers.
(f)
Carefully attach gasket to the metal. Press into firm contact all over.
(8)
Install door holder (15) and secure with four rivets (14) (item 42, appendix H).
(9)
Install two bumpers (13) and secure with two pan head screws (11) and flat washers (12), new lock washers
(10),(item 7, appendix H) and nuts (9).
(10)
Install connector (8) and secure with four pan head screws (7) and self locking nuts (6) (item 1, appendix H).
(11)
Install service valve pipe (Figure 4-26, 4) and secure with four hex head bolts (3) and new lock nuts (2) (item 3,
appendix H).
(12)
Wrap antiseize tape (item 1, section II, appendix E) around the service valve pipe threads (4) and install double
discharge valve (1) and tee assembly (5).
4-82
