TM 9-4310-397-14NOTEThe following procedure is typical for all instrument identification plates. Figure 2-4 indicateslocation of individual plates.(13)Install instrument identification plate (38) and secure with two screws (37).(14)Install decals (33) through (36), as required, by peeling back protective backing and placing decals inposition.(15)Install operating instruction plate (32), four flat washers (31), and secure with rivets (30) (item 37, appendixH).(16)Install slave receptacle plate (29) and secure with four rivets (28) (item 55, appendix H).(17)Install identification plate (27) and secure with four rivets (26) (item 55, appendix H).d.Installation.(1)FrontPanelAssembly.NOTETwo personnel are required to complete installation of component parts.(a)Aline rod (Figure 4-24, 3) and install front panel (Figure 4-25, 19) being careful not to damage rod.Secure front panel with eight pan head screws (17) and flat washers (18).(b)Install cables (14) and (15) onto connector (16) and secure using two cap screws (13).(c)Install cold starting aid (12), four hex washer head bolts (11), and new lock nuts (10) (item 3,appendix H).(d)Feed the push/pull cable assembly (9) through front of panel and install nut (8).(e)Install clamp (7) and secure with hex head screw (6).(f)Install push/pull cable (5) and tighten screw (4).(g)Install wire leads (1) using tags and wiring diagram figure 4-3, hex washer head bolt (3), and newlock nut (2) (item 68, appendix H). Remove tags.(h)Install grommet (Figure 4-24, 5) onto guide plate assembly (6)(i)Install guide plate assembly (6) onto rod (3) and secure with two hex washer head bolts (4).(j)Install knob (2) onto rod (3) and secure with setscrew (1).(k)Install spindle (Figure 4-23, 10), four hex head screws (9), and new self locking nuts (8) (item 5,appendix H).(l)Install new preformed packing (7) (item 8, appendix H) onto hose reel assembly (3) and carefullyinstall hose reel assembly onto spindle (10). Secure hose reel assembly using hose reel bodyretainer (6), two new lock washers (item 4, appendix H), and socket head screws (4).(m)Install braking block (2), and knob (1).4-83
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
