COVERS, PANELS AND DOORS REPLACEMENT. - Continued

TM-9-4310-397-14 Compressor Unit Reciprocating 10 CFM 175 PSI Diesel Engine Driven Trailer Mounted Model CUE67-6DY-TM Manual
Page Navigation
132

TM 9-4310-397-14 4-31. COVERS, PANELS AND DOORS REPLACEMENT. - Continued (n) Connect elbow (Figure 4-22, 3) to hose reel. (o) Wrap antiseize tape (item 1, section II, appendix E) around elbow male end connections and connect hoses (1) and (2). (p) Install control panel gauges per paragraphs 4-33 through 4-46. (2) Rear Panel Information Plates and Insulation. (a) Peel backing off decal (Figure 4-21, 15) and position on rear panel (16). (b) Install caution plate (14) and secure with four rivets (13) (item 55, appendix H). (c) Install shipping data plate (12) and secure with four rivets (11) (item 55, appendix H). (d) Install door holder (10) and secure with four rivets (9) (item 42, appendix H). (e) Fabricate insulation panels (4), (5), (6), (7) and (8), as required, per the following: 1 Cut insulation panel per appendix F. NOTE Paper backing on insulation panel must be removed when installed. 2 Carefully peel paper backing away from around insulation panel edge. 3 Cover exposed insulation panel edge with foil back tape (item 9, section II, appendix E) folded over edges. Be sure tape is under paper backing on insulation panel. WARNING Metal pins pierce insulation panels when installed. Injury to hands can result if care is not taken when installing insulation panels. (f) Remove paper backing from insulation panel and install with sticky side against sheet metal panel. Carefully locate pins and install new clips (3) (item 6, appendix H). (g) Install receptacle (2) and secure with four rivets (1) (item 42, appendix H). (3) Rear Panel. (a) Install rear panel (Figure 4-20, 7) and secure with eight hex washer head bolts (3) and flat washers (4). (b) Install eight hex washer head bolts (5) and flat washers (6). (c) Install two pan head screws (1) and new lock washers (2) (item 10, appendix H). (d) Install air block (10) and secure with four hex washer head bolts (12) and self locking nuts (11) (item 5, appendix H). (e) Secure air block with four hex washer head bolts (8) and lock washers (9) (item 4, appendix H). 4-84

Privacy Statement
Press Release
Contact