TM 9-4310-397-14(d)Install spring caps.(e)Compress valve springs using valve spring compressor and install retainers.Figure 6-28. Valve Installation(2)Install cylinder head.(a) Clean tapped holes in cylinder block for cylinder head cap screws using a tap. Use compressed air toremove debris and any fluids which may be present in cap screw holes.(b)Place new cylinder head gasket (item 53, appendix H) on cylinder block. Do not use sealant. Install dry.(c)Dip threaded end and head end (including washers) of cap screw in engine oil. Remove excess oil fromscrew.(d)Make sure that hardened flat washers are used if cap screws do not have washer heads under head of allcap screws.(e)Install two guide studs in cylinder block (for piloting cylinder head) at locating holes (Figure 6-29, 11) and(12).Figure 6-29. Cylinder Head6-29
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
