TM 5-4310-376-14
Table 3-1. Operator Troubleshooting - Continued
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
10. ENGINE DOES NOT STOP WHEN STOP SWITCH IS TURNED OFF
Check wire connection to switch.
Reconnect wire or replace switch.
11. CAPACITY CONTROL DEVICE DOES NOT OPERATE
Check fittings for leaks.
Tighten fittings.
12. INSUFFICIENT COMPRESSOR OUTPUT
Check belt tension.
Tighten belts.
Section III. OPERATOR'S MAINTENANCE PROCEDURES
3-6. SERVICING
a. Compressor Pump
(1) Oil Fill
Fill crankcase to proper level (bottom thread of oil filler
hole (1)). Refer to lubrication chart. Viscosity should be
selected for temperature immediately surrounding unit
when it is in operation.
(2) Oil Change
Oil changes should be made every 500 hours of operation
or every 90 days, whichever occurs first.
