TM-5-4310-389-14
25.
Slide the sleeve guide over the end of the crankshaft. Fit a new gasket to the end shield; apply grease to hold it
in position. Mount the end shield so that its oil hole is in alignment with the oil hole in the crankcase (figure 5-27)
(use sleeve guide of press-in device No.003-0670).
26.
Press the end shield into position by applying pressure uniformly at diagonal locations (use press-in device No.
003-0670, figure 5-28).
27.
Tighten the screws uniformly and in diagonal sequence.
28.
Oil the front crankshaft journal and mount the front end shield so that the oil hole points towards the injection
pump cover side (figure 5-29).
Figure 5-26. Inserting Bearing Cap Bolts
Figure 5-27. Align End Shield Oil Hole
(Engine Upside-down)
Figure 5-28. Pressing End Shield
Figure 5-29. Align Oil Holes with
Injection Pump Cover
5-20
