TM-5-4310-389-14
36. Insert the tappets. Oil the camshaft journals. Install the camshaft in the bearing bores (figure 5-33).
37. Place the crankshaft right side up.
38. Check the crankshaft gear wheel and install the key if one has not been installed. Heat the crankshaft gear
wheel to 212°F (100°C) and mount it bevel side first on the crankshaft 39. Place the thrust washer on the
journal at the front end of the camshaft (figure 5-34).
40. Install the camshaft gear wheel so that its tooth marked engages in the gap between teeth marked of the
crankshaft gear wheel. Align the camshaft to suit the gear wheel (figure 5-35).
Figure 5-32. Installing Crankcase Cover
Figure 5-33. Installing Camshaft in Bearing
(Engine Block Upside-down)
Bores (Engine Block Upside-down )
Figure 5-34. Positioning Thrust Washer
Figure 5-35. Align Timing Marks
5-22
