TM 9-4310-397-144-31. COVERS,PANELSANDDOORSREPLACEMENT. - Continued(f)Install panel assembly (Figure 4-16, 5) and secure with twenty two hex head screws (1) and flat washers(2).(g)Install five hex head screws (3), flat washers (4).(6)TopPanel.(a)Install bail handle stud (Figure 4-15, 5) and retainer (6) onto access door (2).(b)Fabricate gaskets (3) and (4) per the following:1Scrape off as much of the old gasket material from surface as possible.2Remove old adhesive and gasket residue by scraping.3Cut gasket per appendix F.WARNINGAdhesive (item 5, section II, appendix E) is toxic and flammable. Use in well ventilated areas only.Avoid breathing vapor and avoid repeated or prolonged contact with liquid. Do not use near openflame or excessive heat.4Apply adhesive (item 5, section II, appendix E), to mating surfaces of metal and gasket.5Let both surfaces air dry until adhesive is tacky but will not stick to fingers.6Carefully attach gasket to the metal. Press into firm contact all over.(c)Install access door (2) and secure with three hex head screws (1).(d) Install receptacle (13) secure with rivets (12) (item 64, appendix H).(e)Fabricate insulation panel (8), (9), and (10) per the following:1Cut insulation panel per appendix F.NOTEPaper backing on insulation panel must be removed when installed.2Carefully peel paper backing away from around insulation panel edge.3Cover exposed insulation panel edge with foil back tape (item 9, section II, appendix E) folded overedges. Be sure tape is under paper backing on insulation panel.WARNINGMetal pins pierce insulation panels when installed. Injury to hands can result if care is not takenwhen installing insulation panels.(f)Remove paper backing from Insulation panel and install with sticky side against sheet metal panel.Carefully locate pins and install new clips (7) (item 6, appendix H).(g)Install muffler per paragraph 4-30.4-86
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
