TM 5-4310-368-14
a.
Removal
(1)
Disconnect wire harness at two places.
(2)
Loosen and remove nut, washer and saddle clamp.
(3)
Remove hourmeter from instrument panel.
b.
Installation
(1)
Position hourmeter into hole in instrument panel.
(2)
Position saddle clamp over stud on back of hourmeter. Secure with nut and washer.
(3)
Connect wire harness to hourmeter at two places.
4-46.
AIR CLEANER RESTRICTION INDICATOR
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP
Applicable Configurations
All
a.
Removal
(1)
Disconnect signal tube at rear or indicator.
(2)
Loosen and remove two bolts, two nuts and two lock washers. Remove indicator.
(3)
Remove mounting flange from indicator.
b.
Installation
(1)
Install mounting flange onto indicator.
(2)
Position indicator assembly against top of frame upright.
(3)
Align bolt holes in indicator assembly with bolt holes in frame upright.
(4)
Secure indicator to frame upright with two bolts, two nuts and two lock washers.
(5)
Connect and secure signal tube to rear of indicator.
4-47
