TM 5-4310-368-14
b.
Testing. Use multimeter NSN 6615-00-581-2036 or equal and check continuity of each circuit of the wire
harness.
NOTE
The wire harness is fully color coded. Each size and color must be fully checked.
c.
Repair. No repair is recommended. Replace defective wire harness with a new harness.
d.
Installation
(1)
Install wire harness onto frame. Position wire harness so that wire harness will reach the air pressure
switch and the magneto.
(2)
Connect wire harness as follows: engine oil pressure switch - one place; magneto - one place; alternator
- two places; throttle solenoid - one place; starter solenoid - two places; instrument panel - 25 places; air
pressure switch - three places.
4-50.
ENGINE AND COMPRESSOR OIL DRAINS
This task covers:
a.
Removal
b.
Installation
INITIAL SETUP
Applicable Configurations
All
a.
Removal
(1)
Remove drain plug and drain oil.
(2)
Disconnect oil drain hose from frame fitting.
(3)
Remove support clamps (two for compressor, one for engine).
(4)
Disconnect oil drain hose from engine or compressor.
b.
Installation
(1)
Connect oil drain hose at engine or compressor.
(2)
Secure hose with support clamps (one for engine hose, two for compressor hose).
(3)
Connect hose to frame.
4-50
