TM 5-4310-368-14
a.
Removal
(1)
Loosen and remove bolt, nut and lock washer.
(2)
Loosen and remove four bolts, nuts and lock washers. Remove vibration mounts.
b.
Installation
(1)
Position vibration mount over hole in instrument panel.
(2)
Align bolt holes in vibrations mount with bolt holes in instrument panel. Secure vibration mount to
instrument panel with four bolts, four nuts and four lock washers.
(3)
Secure vibration mount to frame with one bolt, nut and lock washer.
449.
WIRE HARNESS
This task covers:
a.
Removal
c.
Repair
b.
Testing
d.
Installation
INITIAL SETUP
Applicable Configurations
All
Equipment Condition
Paragraph
Condition Description
Battery Disconnected
a.
Removal
(1)
Disconnect wire harness from rear of instrument panel at 25 places.
(2)
Disconnect wire harness from air pressure switch.
(3)
Disconnect wire harness from starter relay at two places.
(4)
Disconnect wire harness from throttle solenoid at one place.
(5)
Disconnect wire harness from alternator at two places.
(6)
Disconnect wire harness at starter at two places.
(7)
Disconnect wire harness at magneto at two places.
(8)
Remove wire harness.
4-49
