TM-5-4310-389-14
NOTE
Viewed from the exhaust air side, the intake duct of a cylinder head is on the right-hand side.
14.
Mount the exhaust manifold, fitted with new gaskets, with the flat side facing upwards.
15.
Close the aperture of the exhaust manifold.
16.
Install the generator so that its V-belt pulley is in alignment with the V-belt pulleys of the crankshaft and
cooling air blower.
NOTE
Tighten the stud passing through the distance sleeve so that play between the securing flanges is eliminated.
17.
Assemble the starter to the mounting flange.
18.
Mount the air filter.
o.
Set the decompression device (Refer to paragraph 3-23).
p.
Starter Gear Ring Removal.
NOTE
Flywheel dismantled.
1.
Cut through the starter gear ring with a hard chisel and remove (figure 5-50).
2.
Heat the new starter gear ring to a temperature of 250F (120C).
3.
Position the new starter gear ring with the bevelled side of the teeth facing away from the flywheel.
4.
Install the starter gear ring on the flywheel and tap it into position so that it seats against the shoulder.
q.
Radial Sealing Ring on Flywheel Side.
5-30
