TM-5-4310-389-14r.Crankshaft Seal Replacement.1.Apply puller No. 003-0733 and draw off crankshaft seal (figure 5-53).2.Grease slightly sealing lip of new radial sealing ring.3.Install crankshaft seal in such a way that lip faces inwards. Press on ring with installation device (figure 5-54).NOTEPay attention to contact traces of crankshaft seal. If the contact surface shows on the crankshaft (afriction groove caused by the radial ring), displace the latter axially in the front cover.NOTEWhen moving the seal, observe correct depth of installation (pressed in). Depth 1 (figure 5-55),outside flush with front-end cover. Depth 2 (after shifting in front-end cover to be flush inside):maximum 0.039-inch (1.0 mm) (figure 5-51).s. End Shield on Flywheel Side.NOTEFlywheel dismantled.Figure 5-53. Remove Crankshaft SealFigure 5-54. Pressing on Radial Seal Ring withFitting Device5-32
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
