TM-5-4310-389-14
4.
Mount the cooling air blower and check the two V-belt pulleys for alignment (figure 5-48).
5.
If the V-belt pulleys are out of alignment, correct by varying the number of shims under the cooling air
blower.
6.
Attach the exhaust air plate to the front vertical plate (figure 5-49).
7.
Mount the vertical plate on the flywheel side of the engine.
8.
Install engine head temperature probe. Mount the top cover plate.
9.
Connect the fuel lines.
NOTE
Clips should be used to attach the fuel supply line for cylinder #1 to the crankcase and the supply line
for cylinder #2 to the front vertical plate. Install a rubber sleeve between the clip and fuel line.
10.
Install the fuel return line fitted with new gaskets.
11.
Screw on a new fuel filter finger-tight.
12.
Hook the top of the air cowling to the upper cover plate and secure at the bottom with a screw.
13.
Mount the intake manifold, fitted with new gaskets, with the flat sides facing upwards. Torque to 20 lb-ft.
Figure 5-48. Checking Alignment
Figure 5-49. Attaching Exhaust Air-Plate
of V-Belts
to Front Vertical Plate
5-29
