TM 5-4310-354-14
b. Installation.
5-12.
Engine Assembly.
(1) Install the air compressor assembly on the
a. Removal.
unit as shown in figure 5-6.
(2) Connect the speed control rod stop block
to compressor unloader lever. Connect
speed control rod return spring (figure
(2) Remove the exterior comp onents of
enclosure group (figure 4-12), quick start
assembly (figure 4-13), overspeed switch
(3) Connect the idle control cable and
compressor unloader cable (para 4-63).
compressor air cleaners (figure 4-15).
(4) Connect the oil separator inlet hose (figure
(3) Disassemble the compressor enclosure
group to extent necessary to gain access
sensing bulb (para 4-56) and oil
to the engine assembly (figure 4-17).
temperature shutdown switch (para 4-70).
(4) Remove the radiator and oil cooler group
(5) Install the
blowdown
valve
assembly
(5) Disconnect the fuel lines, hoses, and
(6) Install the compressor air intake lines,
fittings as necessary to remove the engine
hoses, and fittings (figures 4-21 and 4-22).
assembly (figure 4-20).
(7) Assemble the compressor enclosure
(6) Remove the air lines, hoses, and fittings
components removed to gain access to
the compressor (figure 4-17).
(7) Remove the instrument panel assembly
(8) Install the compressor and engine air
cleaner assemblies (figure 4-15).
(8) Remove the air compressor assembly
(9) Install the exterior components of
compressor enclosure removed to gain
access to compressor (figure 4-12).
(9) Attach a suitable lifting device to the lifting
eyes on the engine assembly and remove
the assembly from the unit as shown in
5-23
